Orbital
Orbital Vector panel

Orbital manual · 2 HP

Orbital Vector

Turns where a sound is, and how fast it really moves, into five control voltages. Open a filter as a sound comes close, pan a delay with the orbit, or draw the orbit on an XY scope.

Connecting

Place Vector in the Orbital chain, next to Uno or further along it. It only reads the scene, so it never changes the sound.

Controls

ControlWhat it does
Source buttonSteps through Uno, MAS 1, MAS 2 and MAS 3, skipping any that aren’t there.
ScreenThe followed satellite’s number, in the source’s colour. “–” = nothing to follow.
SATSteps through satellites 1–5 of that source, skipping any that aren’t there.
SLEWA glide on all five outputs, from about 1 ms to 2 s. The angle glides the short way round.

Outputs

JackWhat it carries
ANGWhere the satellite is round the circle: front = bottom of the range, all the way round = top.
DISTNear (bottom) to far (top).
SPDHow fast the satellite really moves, measured from what it does: orbiting, Position moves, CV, start and stop. Anticlockwise below the middle, clockwise above, stopped or frozen = middle. SNAP steps don’t make it spike.
XLeft (bottom) to right (top).
YBehind (bottom) to in front (top).

X and Y shrink as the satellite comes near, so one XY pair is a full 2D position. The middle of the range is the listener.

If the followed satellite is deleted, the next one takes over with a short slide instead of a jump. If the source or satellite is missing, every output glides to the middle of the range.

Right-click menu

  • Range: 0–10 V or ±5 V.
  • X/Y: shrink with distance (default) or full circle.
  • Poly: Off, Sources (4 channels: Uno, MAS 1–3) or Satellites (5 channels: the source’s satellites 1–5).